2008 Dodge Ram 5500
Update: Seller added transmission fluid and the truck acts normal. Seller states it has been driven to Billings, MT 3-4 times this year with out issue. We noticed a small coolant leak from a fitting coming of the cylinder head. The ignition cylinder is picky. You have to wiggle it just right. The 4x4 selector lever is disconnected due to a plastic fitting being broke, seller states 4x4 works.
We drove it after the fluid and filter was changed and it shifts and moves fine. We also put it in 4x4 and it works.
Odometer shows 213,738 miles.
Service bed:
Reading Truck Body. 11ft Service bed + 1.5ft work bench rear bumper. Approximately 8ft wide. It has Wilton vise on the back and some tool boxes.
Crane: Auto Crane Model 3203 PRX. It’s electric over Hydraulic. It comes with the wired controller. We turned it on and it worked. It has Manual outriggers.
Welder: Bobcat 225 AC/DC. It shows 100 hours on the hourmeter. We cranked it but couldn’t get it to start. We were told the fuel pump on it is bad. Comes with leads. It’s missing one side panel.
Compressor:
Honda Engine w/ 3 Piston Compressor. It feeds a ≈20 gallon tank mounted under the truck.
Torches: Small acetylene torch set in right rear corner of bed.
Tires: 225/70R19.5
